Bbk-performance 1751 Manual de usuario descargar pdf

2.0L Zetec 65mm Throttle Body

Part #1751

INS-078

Step 1

Raise hood and disconnect negative (–) battery terminal.

Step 2

Unclamp and remove air cleaner inlet tube between the throttle body and air box.

Step 3

Unplug the throttle position sensor, located on the right side of the throttle body when facing the engine.

Step 4

Disconnect the throttle and cruise control cables from the throttle linkage.

Step 5

Remove the (3) three bolts attaching the throttle/cruise control cable bracket to the throttle body.

Step 6

Remove the (4) four mounting screws attaching the throttle body to the intake manifold, then carefully remove

the throttle body from the vehicle.

Step 7

Remove the throttle position sensor from the stock throttle body and attach to the BBK throttle body using the

new supplied hardware. (The sensor will sit at a different angle, however, the relationship between the sensor and

the throttle shaft are engineered to be the same so that the proper voltage will remain at the sensor.)

Step 8

Install the new supplied paper type gasket onto the manifold (do not use the factory rubber gasket) and reinstall

the new BBK throttle body onto the intake manifold. (Great care must be used to not cross-thread or over tighten

the self-threading screws attaching the throttle body to the manifold.)

Step 9

Reassemble and reinstall all components in reverse of disassembly.

Step 10

Reinstall negative (–) battery terminal.

Step 11

Start vehicle without touching the accelerator pedal and allow the vehicle to run until full operating temperature is

achieved. If the idle speed after this period of time is incorrect, a slight adjustment of the set screw setting the

position of the throttle linkage may be made using a 3mm Allen wrench.

INSTALLATION INSTRUCTIONS

www.BBKPERFORMANCE.com

IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).

BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).

Indice de contenidos

Pagina 1 - Part #1751

2.0L Zetec 65mm Throttle BodyPart #1751INS-078Step 1Raise hood and disconnect negative (–) battery terminal.Step 2Unclamp and remove air cleaner inlet

Comentarios a estos manuales

Sin comentarios

Bbk-performance 1751 Manual de usuario

Busca en linea o descarga Manual de usuario para Para El Coche Bbk-performance 1751. BBK Performance 1751 User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Para El Coche Bbk-performance 1751