Bbk-performance 2501 Manual de usuario
Busca en linea o descarga Manual de usuario para Para El Coche Bbk-performance 2501. BBK Performance 2501 User Manual Manual de usuario
- Pagina / 1
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Gripp Lowering Spring Kits for
1979-Current Ford Mustang
INS-015
Step 1 Place all four corners of the vehicle on jackstands or use a lift.
! CAUTION !
Use extreme caution under vehicle
Step 2 Remove all four wheels from the vehicle.
Step 3 Next using a floor jack under the rear axle put enough pressure on the suspension to preload it.
Step 4 Inside of the car take off the covers for the rear shocks and unfasten them. Next lower the floorjack slowly until
the axle is fully extended. Pull out the factory springs.
Step 5 Make sure to put rubber isolator pads back on to the new springs before installing them.
NOTE
Both pigtails off the spring should be in a straight line with
the rear axle, with both of them facing the drivers side.
(See Photo A).
Step 6 Front springs: Disconnect the front calipers and hang them up out of the way. Disconnect the endlinks from the
lower control arms. Them scribe a line around the strut mount bracket for initial alignment specifications.
Step 7 Place a floorjack under the front rotor and apply enough pressure to preload the spring.
! CAUTION !
Do not bend the dust shield if so equipped
Step 8 (Use of spring compressor is recommended). Remove the three strut mount nuts and slowly
lower the floorjack,
pulling the strut out of the wheelwell when possible.
! CAUTION !
Use extreme caution when working around the springs
Step 9 Replace the rubber insulators onto the
new springs and reinstall making sure
pigtail seats in the lower control arm
properly.
Step 10 For reassembly reverse previous steps.
(The front end should be realigned after
2 or 3 days time to make sure springs
have settled first).
INSTALLATION INSTRUCTIONS
A BBK Company
www.BBKPERFORMANCE.com
Photo A
IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).
BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).
1
Indice de contenidos
Pagina 1 - 1979-Current Ford Mustang
Gripp Lowering Spring Kits for1979-Current Ford MustangINS-015Step 1 Place all four corners of the vehicle on jackstands or use a lift.! CAUTION !Use
Relacionado con productos y manuales para Para El Coche Bbk-performance 2501
(1 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.815 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales